DIY

How to make a simple and free plant waterer



Yesterday I was filling up my plant waterer and realized that I have been using it for over 15 years. I made it when I was a kid and it has worked great! It is simple and free so I thought I would show how you can make it.



Start with a simple milk jug.


Poke a small hole through the lid, then get a cheap pen. Take the ink out so only the housing is left. Put that through the hole you made then use hot glue to secure it. Make sure when you have it dry that you set it to dry at an angle. This makes it much easier to use.


You don't have to do anything fancy. Just about any glue job will work as long as it is sealed well.




You should be able to use this for years to come! Even when the milk carton gets old, the lids have stayed the same throughout many years.


I made this when I was growing up and have used it for many years. It does not leak, holds a lot of water and comes out in a nice small stream. It is great for any size of house plant.



The pen allows you to get into tight spaces if you need to.

About Unknown

3 comments:

  1. Ummhh.. maybe u'll find it strange, but loooong time ago someone invented watering can for this purpose.

    http://www.germes-online.com/direct/dbimage/50299338/Watering_Can.jpg

    And you could buy some on ebay at few bucks..

    ReplyDelete
  2. Great Idea. Recycling at its best. :)

    As for the previous person have you ever heard of being ingenous and not spending every penny or dollar you earn?

    I love the idea really. :)Thanks for sharing!

    ReplyDelete
  3. That is very clever idea, simple and it is eay to make it.



    thank you sharing with us.

    ReplyDelete

Powered by Blogger.